In June, the branches of snow are soft and tough, which can withstand curling. Therefore, bonsai modeling is generally divided into straight dry type, qiuqu type, cliff type and so on.
If the basin is relatively high, it can be cultivated into cliff type. Cliff type is divided into half suspension, full suspension and small suspension according to the different inclination.
Half overhanging means that the trunk basically runs out of the spout. The whole overhanging trunk should hang down 45 degrees from the basin mouth, and the small overhanging trunk should generally hang down about 30-40 degrees.
In March, the June snow was propagated separately, and from April to October, the cuttage was propagated.
It can also be processed by the combination of cutting and binding. Panza is usually carried out from half fallen leaves in winter to sprouting in spring. In June, the trunk and main branches of snow are Panza with wire, and the twigs are pruned.
In February March, when transplanting the upper basin, the purple sand basin or glaze basin with deep color is selected. The depth of the basin is shallow, which is in contrast with the color of the flower. The basin soil needs a sandy loam rich in organic matter, loose and fertile, with good drainage and permeability.
Turn the basin every 1-2 years, in the spring 2-3 or in the late autumn, discard all the old soil, trim the roots properly, and carry out the root lifting in combination with turning the basin, forming the hanging roots to improve the ornamental value.
From the half fallen leaves in winter to the sprouting in spring of the next year, plastic pruning shall be carried out to cut off short and long branches, excessive and long branches, fine and weak branches, and disease and insect branches. During the growth period, coring, sprouting and branching shall be carried out to maintain a beautiful shape.
In June, the snow branches are relatively soft and suitable for Panza. In the early stage, the skeleton should be pulled well, the main branches should be fixed, and the stocking should be increased.
In June, snow root system is developed, hanging root and exposing claw. It is very important to manage root and distribute stone in the maintenance stage. The design scheme and stone selection must be careful.
During the period of pile raising, large amount of fertilizer and large amount of water shall be managed, and during the forming period, it shall be controlled according to the specific situation.
Don't use less water. Snow in June is very sensitive to water. If you use too little water, there may be consequences of dead branches and piles.
