To choose a healthy mother plant, and then select the most robust branches from above. After selection, cut it out, and then cut it into 15 cm or so section by section of the spike. After cutting, trim the leaves, leaving only two or four leaves.
There are not too many requirements for the basin, ordinary clay basin can be used. The requirements for soil are relatively high. It is necessary to use permeable, loose and permeable soil, and sandy soil can be selected.
If you want to cut a big leaf and make it into a pillar, you need a pillar. Choose a thick bamboo pole as the pillar. Wrap it in thin thread and place it in the center of the flowerpot. After adjusting the position, fill in the soil.
The next step is to insert the cuttings into the soil. During the specific operation, the insert bar can be inserted around the pillar. Note that the leaves should face the outside, cutting from the inside to the outside. It should also be noted that the depth should be controlled at about one third of the spike.
After inserting, first pour through the water, and then put it in a cool and airy place. About half a month later, we can observe the phenomenon of rooting.
