It's a troublesome thing to water more meat. If you use a watering pot, it will be poured on the leaves carelessly, causing rotten heart and stem. How to solve this pain? Simple! A plastic bottle can achieve!
Find a plastic bottle, keep the top plastic cap, don't throw it away!
Take off the plastic cover, hold the plastic cover with pliers and other tools, bake the outside of the plastic bottle with lighter on a small fire, and make it soft
As shown in the figure below, find a toothpick in the middle of the plastic cover, and slowly poke it from the inside to the outside. When you poke it, be sure not to shake it left or right until a beautiful little cone is poked.
Poke out the beautiful cone, don't rush to take off the toothpick, put it in a ventilated place, dry it naturally, and then take off the toothpick after it is completely shaped.
We can use scissors to cut off the tip of the top properly, so that the water can flow out.
The last step is to fill the plastic bottle with water and cover it with a pre made lid. When watering, pinch the body of the plastic bottle, and the water will flow out of the cap.
This kind of self-made watering can't flow to the fleshy leaf heart because of its small water flow. It will cause the rotten heart, stem and leaf. It's better to use it than the fleshy watering can bought with money
Of course, if you feel that the above operation is troublesome, you can directly buckle a hole in the bottle cap, insert the straw into the hole,
In particular, the size of the hole on the bottle cap should be consistent with the caliber of the pipette, or it will leak.
Plastic bottle cutting, flowers to you introduced a lot, but today flowers teach you this method, can be more than other methods rooting rate Oh ~ next to Gardenia as an example, give you a detailed description.
Usually develop the habit of collecting plastic bottles, plastic bottles or beverage bottles, do not throw away!
Cut off a half woody branch of gardenia, the best half a year to a year. Use a wallpaper knife to cut the bottom of the branch at a 45 degree angle, so that the cut presents a horseshoe shape, increases the contact area with water, and is easier to root.
Find 1 foam boards and cut a circle according to the diameter of the bottom of the foam.
Drill a small hole in the middle of the foam, then remove the bottom leaves of the Gardenia branches and insert them into the small holes of the foam board.
Put the plastic bottle horizontally, and cut it 1 /3 from the top to the bottom with a wallpaper knife. Pay attention not to cut the 1 /3 of the upper part completely, leave a little bit, so that the upper and lower parts can be connected together without breaking.
Pour water into the lower part of the plastic bottle. The water level is about 3 /4 of the lower part of the plastic bottle.
Insert the foam of Gardenia branches into the lower part of the plastic bottle, above the water. Ensure that the branches below the foam touch moisture.
Return the top half of the plastic cap and tape the cut. Remove the lid from the plastic bottle.
Put the cutting device in the place of light and ventilation, about 2-3 weeks, the branches will grow the root system of white flowers, and there is no need to add water during
Autumn! When it's time to plant again, do flower friends buy seedling pots and pieces everywhere? In fact, don't spend that unjust money, your plastic bottle is a super good seeding artifact!
Prepare a plastic bottle, as shown in the picture, horizontally, up, middle and down, cut it into three parts on average, put the middle one aside and don't use it.
Fill the bottom plastic bottle with soil, pour it through, and then sprinkle seeds.
Seal the incision with plastic wrap, keep moisture and heat, wait for 1-3 weeks, the seeds will germinate!
When the seedlings are all out, you can tear off the plastic wrap! But the seedlings are too weak to withstand the strong wind and low temperature. At this time, 1 /3 of the plastic bottles we cut can be used! As shown in the picture, just like a hat, you can cover it, not only improve the humidity, but also protect the seedlings.
