Garlic plays a very important role in flower culture. No matter it is antiseptic, antiseptic and germinating, or even killing mosquitoes and ants, the effect is very good!
1. Prepare the peeled garlic and sterilized scissors.
2. Cut the rotten part of the root system with a knife, and make sure that there is no rotten part on the remaining root system.
3. Cut the garlic and apply it directly to the root wound. Make sure that the garlic mucus is all on the wound. After that, put the Money Tree in a cool and ventilated place, dry the mucus, and finally put it in the basin again.
1. Prepare peeled garlic and a watertight bottle.
2. Mash all the garlic until it becomes mushy, then add in the cold boiled garlic, the proportion is about 1:3, and then stir evenly to make garlic solution.
3. Apply the prepared Garlic Solution on the buds, which can make the flowers sprout 5-8 days in advance, especially for camellia and osmanthus.
Ginger has a strong smell, which is disliked by spiders and aphids, so ginger can be used to drive away mosquitoes.
1. Find a piece of fresh ginger from home, mash it completely and soak it in clear water. The concentration is about 1:20, and the best soaking time is more than 24 hours.
2. Take the soaked ginger solution, put it in the spray pot, and spray it directly on the plants with pests. Spray it once in about 2-3 days, lasting for more than 5 times.
3. Spraying ginger water on plants can not only kill red spider, aphid and other pests, but also treat leaf spot and black rot. the effect of sterilization and disinfection is also very good!
Every time I clean the waste oil from the lampblack machine, it makes the flowers sick. I don't want to see it for a second time. In fact, the waste oil is used to raise flowers, especially the Clivia and orchid, which like oil crops. The effect is very good!
1. Take out all the waste oil from the lampblack box. Pay attention that diesel oil, engine oil, etc. cannot be used.
2. Poke 3-5 small holes around the flowerpot, each hole is about 5-7cm deep. Note that the small hole must be poked along the edge of the flowerpot, so as not to damage the root system.
3. Pour the waste oil in the lampblack machine into the small hole, about 0.5cm, then fill the soil and cover the small hole completely.
4. Finally, we need to remind you that the flowers that can use waste oil basically like oil crops, such as Junzi orchid, orchid, geranium, Christmas Cactus, etc., while for jasmine, gardenia and other flowers, it's better not to use them.
Beer contains a lot of organic substances and microelements, which can supplement nutrients to flowers and make them grow more prosperous!
Mix the remaining beer or expired beer with water in a ratio of 1:50 to form a solution, and then put it in a watering can to water the flowers directly, about once a half month, which can make the plants grow stronger and stronger!
Mix the beer and water in the proportion of 1:50 into a solution, then take a soft cloth, dip the beer solution, and directly wipe the leaves. This method is very effective for the flowers with large leaves such as Chloranthus and Clivia.
Vinegar is acid, watering can improve the soil pH, so that some acid flowers will not cause yellow leaves because of iron deficiency.
When finding the yellow leaves of flowers at home, you can add 3-5 drops of vinegar when watering the flowers, about 3-5 times to avoid the yellow leaves.
Water the flowers with vinegar, suitable for gardenia, jasmine, camellia and other flowers like acid soil.
White sugar solution can not only promote the rooting of cuttings, but also water flowers for a long time, and can also promote the growth of plants, to solve the situation of not flowering.
1. Pour white sugar into 40 ℃ warm water and stir it into solution, the proportion is about 1:9.
2. Wait until the sugar solution is dried to the same room temperature, then insert the cuttings into the solution, soak for about 20 minutes, then take them out and put them in a cool and ventilated place to dry.
3. After drying the wound, wash it with water, and then cut it directly.
