1. Prepare a Clivia, break off the leaves from the bottom to the top (be sure to take the white part), and soak it in rooting powder solution before cutting.
2. Then insert the leaves of Clivia into the nutrition Cup we prepared. The substrate can be nutritious soil or vermiculite.
3. Sit the cut Clivia in the tray, use the way of soaking basin to make up water for the plant, generally 30 days can grow new roots.
4. For the rooted Clivia, we can find a large flowerpot to plant. The soil can be mixed with coniferous soil and sand. It's better to incline planting for germination.
5. At ordinary times, you can use your hands to peel the soil, feel the substrate inside dry, and soak in the basin for 30 minutes. As long as you take good care of it, you will be able to hold new buds in three months or half a year.
6. If the plant does not hold new buds, we can cut a small mouth with a knife on the inside of the leaves close to the soil, smear vitamin B6 injection, and induce it to germinate.
1. When we plant long-lived flowers in the leaves, we'd better choose the leaves with obvious bud points, and when breaking the leaves, the petioles should have as many tissues on the stems as possible, so that the buds will grow easily.
2. Throw the broken leaves at the astigmatism and ventilation place, dry the wound for 2 hours, hold the leaves in hand, and insert the petioles into the soil obliquely. (leaves face up best)
3. After cutting, we use the method of soaking basin to replenish water for the plant until the soil surface is wet, and then put it in a place where the sun can't reach and the air is ventilated.
4. It is usually felt that the surface of the soil is white and watered once. Generally, new roots can grow in 10 days and sprouts in 30 days.
5. After sprouting, transplant the longevity flower into the seedling cup or small flowerpot, and gradually increase the light intensity until the seedling can receive the whole day's sunshine.
6. When the seedlings grow to four pairs of leaves, pick the heart, pinch off the top two pairs of leaves, and when the lateral branches grow four pairs of leaves, pinch again, and repeat three times, the flowers will flourish.
1. Select a robust leaf of snake plant, use a sharp scissors (disinfect with alcohol before use), and cut the snake plant into several small sections (length is more than 5cm).
2. Put the cut snake plant leaves in the place of astigmatism and ventilation for half a day, wait until the wound is dried, and then carry out hydroponics, otherwise it is easy to infect the germs.
3. Insert the dried snake plant into the water vertically, and the water depth can be 3-5cm. Pay attention not to insert it backwards, or it will not take root.
4. Put it at the astigmatism place in the early stage of hydroponics, change the water to be dried once every 4-5 days on average, and new roots will be born in about 10 days.
5. After one month of hydroponics, we observed that when there are more rooting, we can drop one drop of nutrient solution into the water when changing water, and then new shoots can be produced in about two months.
6. When the seedlings grow to 10cm, they can be taken out and planted in the soil. When transplanting, we can keep the mother leaves or break them off.
7. After transplanting, pour a root fixing water and put it in a slow basin where there is light and ventilation. If the seedlings do not soften after one week, they can be maintained normally.
